Seat Belt Bulletin

Tuesday, Jun. 16 2015

Over the past 2 weeks, the PPIHC has hosted 2 tire testing weekends. During this time it has been identified that several teams/vehicles were observed using 2″ lap belts. The requirement as stated on page 25 – 7.1 in the rule book is the following:

  • 7.1 Minimum width of lap belt is 3 inches and shoulder harness is 2 inches. Minimum width of anti-submarine belts is two inches (2″).

This rule has been in place for several years and has not changed. Please make sure that your entry complies with this and any other safety requirement prior to Technical Inspection on June 22nd or the vehicle will not be allowed to participate until corrected.

Leave a Reply

You must be logged in to post a comment.